If your sink stopper is stuck or has fallen out, don’t despair! Putting it back in is a relatively easy task that can be completed in just a few minutes. However, before you begin, it’s important to make sure that the sink is empty and the drain is clear of any debris. Once you’ve done that, you can follow these simple steps to get your sink stopper back in place.
First, locate the small hole in the center of the drain. This is where the stopper will be inserted. If the hole is clogged, use a toothpick or a small piece of wire to clear it out. Next, take the stopper and insert it into the hole. Make sure that the stopper is facing the correct way, with the rubber gasket facing down. Finally, push down on the stopper until it clicks into place. You may need to use a little force to do this, but be careful not to damage the stopper or the sink.
Once the stopper is in place, test it to make sure that it’s working properly. Fill the sink with water and then pull up on the stopper. The water should stop flowing. If it doesn’t, double-check that the stopper is properly inserted and that the rubber gasket is forming a good seal around the drain hole. If the problem persists, you may need to replace the stopper or the gasket.
How To Put Sink Stopper Back In
If you’ve ever had to put a sink stopper back in, you know that it can be a frustrating experience. The stopper can be difficult to grip, and it often seems like it doesn’t want to go back in the drain. But with a little patience and the right technique, you can get the stopper back in place in no time.
Here are the steps on how to put a sink stopper back in:
- Remove the old stopper. If the old stopper is still in place, you’ll need to remove it before you can put the new one in. To do this, simply pull up on the stopper until it comes loose.
- Clean the drain. Once the old stopper is removed, you’ll need to clean the drain. This will help to ensure that the new stopper will fit properly and won’t leak.
- Apply a little petroleum jelly to the O-ring. The O-ring is a rubber gasket that helps to seal the stopper in place. Applying a little petroleum jelly to the O-ring will help to lubricate it and make it easier to insert.
- Insert the new stopper. Align the stopper with the drain hole and push it down until it is firmly in place.
- Test the stopper. Turn on the water and check for leaks. If there are any leaks, you may need to adjust the stopper or replace the O-ring.